Running KC lights to my upper windshield, where to kid wires?

[Jeep4Life]

I picked up a set of used KC lights and now going to mount them above the windshield, but can't seem to figure out how to get the wires up there, or how to hide these. Can you help me with this please?

 

[smritte]

if you look, there's a few variations of this Wire Hider. That one is from KC themselves.
I dont remember where my friend got his but it was thinner and a hard plastic. We used it on his 4Runner.
Look up hiding wires along windshield.

 

[M Kesik]

Can’t you run it through the seal between the removable top from the backside? That being the case, run it up under the molding on the back side of windshield.

 

[Martin Cunningham]

Can’t you run it through the seal between the removable top from the backside? That being the case, run it up under the molding on the back side of windshield.

If it rains, you'll get water coming in and dripping down the wire.

 

[SpaceRat]

I'm looking at the same lights. That bracket that holds them on top should hid the wire heading up. So you will need to run from the lower windshield and route up

 

[Tripping4x4]

Did you get the lights installed? Where did you end up running the wires?

 

[Jeep4Life]

Not yet, I have them here but hope to go for it this upcoming weekend.

 

[alex]

I have KC lights and I have the wire wedged under the mount on passenger side.